First, try to use the sealant, if necessary, paint can be used to achieve the ideal sealing effect;
Second, the rubber seal should be carefully checked before the appearance of the quality of the assembly; use of special tools to suppress, to avoid knocking deformation;
Third, according to the provisions of filling lubricants, regular cleaning dredge and check valve;
Fourth, in very clean conditions for assembly, parts of the work surface without bumps, no scratches, burrs and other attachments;
Fifth, strict operating procedures, the seal should be properly installed to prevent not in place can be deformed;
Sixth, master the seal of the performance specifications and the use of requirements, the timely replacement of failure pieces;
Seventh, for the side cover class thin-walled parts, the use of sheet metal cold to do correction; easy to wear shaft hole parts can be used metal spraying, welding, adhesive, mechanical processing and other processes to achieve the original size;
Eighth, nuts slide wire cut off, loose should repair or replace the new pieces, and screw to the specified torque.